all small block, with transistor ignition, without air conditioning
Additional information
Lectric Limited Part #
VVR6500A
OEM Part #
02988198
WebID Part #
id-vvr6500a-0002
Weight
0.1 lbs
You have not selected a vehicle
Also fits*:* This fit is only a guideline. Please verify the fit by entering your specific vehicle.
Make
Model
Years
CHEVROLET
CORVETTE
1965
CHEVROLET
FULLSIZE 1958 & UP
1965
TECH NOTES:
This harness is used to filter-out ignition noise caused from the engine harness. Without this Adapter Harness, noise induced into the T.I. harness from the engine harness could cause your engine to mis-fire. This harness contains a noise canceling diode.
The actual application of this harness is vague. No documentation is available as to whether it is used on a big block, small block or both.
CONNECTS TO: - Ground (to horn relay mounting bolt) - Ground (to radio capacitor mounting screw on voltage regulator) - Voltage Regulator Connector (on engine harness)
-replacement made in Taiwan-, all Replaces flasher #'s 142, 143, 144, 145, 223, 224, 323,... see more-replacement made in Taiwan-, all Replaces flasher #'s 142, 143, 144, 145, 223, 224, 323, AP273, AP373, SF224, SF323, SF323YB, ZN232, and ZN332. Will flash turn signals at the correct rate, unlike other aftermarket flashers!! (has a silver round metal housing)
This handy cut-off switch lets you quickly and easily disconnect your battery for safety when... see moreThis handy cut-off switch lets you quickly and easily disconnect your battery for safety when servicing your vehicle or in storage, to eliminate battery drain while vehicle is not in use, and for security as an anti-theft device. Install on the negative post of your battery, attach battery cable to the switch and you're done! To engage power just hand tighten the green knob. To disconnect power, slightly loosen the knob or, on this top-post model, completely remove the knob to discourage unauthorized use while stored at home, parked, or when traveling.