located on passenger side cylinder head, -O.E.M. replacement made in U.S.A.-, V8, small block, with A/C
Additional information
Lectric Limited Part #
06489785
OEM Part #
06489785
WebID Part #
id-06489785-0013
Weight
0.1 lbs
You have not selected a vehicle
Also fits*:* This fit is only a guideline. Please verify the fit by entering your specific vehicle.
Make
Model
Years
CHEVROLET
FULLSIZE 1958 & UP
1970
CHEVROLET
CORVETTE
1970 - 1974
CHEVROLET
CAMARO
1970 - 1971
CHEVROLET
CHEVELLE/EL CAMINO/MONTE CARLO/MALIBU
1970
CHEVROLET
CHEVY II/NOVA
1970
TECH NOTES:
Introduced in 1970, the Transmission Controlled Spark (T.C.S.) System controls exhaust emissions by eliminating vacuum advance in the lower forward gears, while at operating temperature.
This Transmission Controlled Spark (T.C.S.) Switch is one component of the emission system. It screws into the cylinder head to detect coolant temperature. When activated, this switch is designed to override this system, until the engine temperature reaches a set temperature. This allows vacuum advance in all gears, thereby preventing stalling after starting.
This handy cut-off switch lets you quickly and easily disconnect your battery for safety when... see moreThis handy cut-off switch lets you quickly and easily disconnect your battery for safety when servicing your vehicle or in storage, to eliminate battery drain while vehicle is not in use, and for security as an anti-theft device. Install on the negative post of your battery, attach battery cable to the switch and you're done! To engage power just hand tighten the green knob. To disconnect power, slightly loosen the knob or, on this top-post model, completely remove the knob to discourage unauthorized use while stored at home, parked, or when traveling.
column shift automatic trans. ****CUSTOMER MUST SUPPLY A DONOR HARNESS WITH USABLE WARNING LIGHT POD... see morecolumn shift automatic trans. ****CUSTOMER MUST SUPPLY A DONOR HARNESS WITH USABLE WARNING LIGHT POD SOCKETS & SPEEDOMETER LIGHT SOCKETS. PHONE-IN ORDER ONLY; PLEASE DO NOT ORDER THIS ITEM ONLINE.****
(wiring from speaker to speaker harness connector, 1 required per speaker) Use when installing aftermarket... see more(wiring from speaker to speaker harness connector, 1 required per speaker) Use when installing aftermarket speakers. Made to solder wires directly to aftermarket speaker and with correct connector for connection to original wiring.