front single center dash speaker, Use when installing original, replacement, or aftermarket speaker. Made with correct connector for hook-up to current GM replacement speaker and correct connector for connection to original radio or radio harness. You can cut off connector for hook-up to current GM replacement speaker and solder wires directly to original speaker (as was done originally) or aftermarket speaker.
Additional information
Lectric Limited Part #
33428
OEM Part #
07933345
WebID Part #
id-33428-0015
Weight
0.1 lbs
You have not selected a vehicle
Also fits*:* This fit is only a guideline. Please verify the fit by entering your specific vehicle.
-O.E.M. style replacement-, with Intermittent/Pulse Wipers (does not include WINDSHIELD WASHER PUMP or INTERMITTENT/PULSE WIPER... see more-O.E.M. style replacement-, with Intermittent/Pulse Wipers (does not include WINDSHIELD WASHER PUMP or INTERMITTENT/PULSE WIPER MODULE)
ignition module inside distributor to coil, V8, Pontiac 301 C.I. Note: This is the improved... see moreignition module inside distributor to coil, V8, Pontiac 301 C.I. Note: This is the improved 1978-91 style part that is a direct replacement for the original style Distributor Module to Coil Harness. TOTALLY STOCK APPEARANCE WITH DISTRIBUTOR CAP INSTALLED!!
This handy cut-off switch lets you quickly and easily disconnect your battery for safety when... see moreThis handy cut-off switch lets you quickly and easily disconnect your battery for safety when servicing your vehicle or in storage, to eliminate battery drain while vehicle is not in use, and for security as an anti-theft device. Install on the negative post of your battery, attach battery cable to the switch and you're done! To engage power just hand tighten the green knob. To disconnect power, slightly loosen the knob or, on this top-post model, completely remove the knob to discourage unauthorized use while stored at home, parked, or when traveling.
blade width .04". If you need to remove a metal terminal from its plastic connector,... see moreblade width .04". If you need to remove a metal terminal from its plastic connector, this genuine Aptive/Delphi tool allows you to depress & release the locking tang on most terminals used by GM from 1950-80s. Not for use with Weather-Pak terminals. Made in USA.