6 volt converted to 12 volt, with 1973-85 SI series internally regulated alternator Note: This harness is used along with the existing stock harnesses or CUSTOM DESIGN SERIES WIRING HARNESS SET part #05053. Use when converting a 6 volt to a 12 volt system.
Additional information
Lectric Limited Part #
30380
OEM Part #
92963448
WebID Part #
id-30380-0002
Weight
4.0 lbs
You have not selected a vehicle
Also fits*:* This fit is only a guideline. Please verify the fit by entering your specific vehicle.
After simple installation of this kit your courtesy lamps will remain on for a user... see moreAfter simple installation of this kit your courtesy lamps will remain on for a user adjustable amount of time (0-60 seconds), or until the ignition switch is turned to on or accessory. At the end of the delay function, the courtesy lights will gradually fade to dark.
blade width .08". If you need to remove a metal terminal from its plastic connector,... see moreblade width .08". If you need to remove a metal terminal from its plastic connector, this genuine Aptive/Delphi tool allows you to depress & release the locking tang on most terminals used by GM from 1950-80s. Not for use with Weather-Pak terminals. Made in USA.
This handy cut-off switch lets you quickly and easily disconnect your battery for safety when... see moreThis handy cut-off switch lets you quickly and easily disconnect your battery for safety when servicing your vehicle or in storage, to eliminate battery drain while vehicle is not in use, and for security as an anti-theft device. Install on the negative post of your battery, attach battery cable to the switch and you're done! To engage power just hand tighten the green knob. To disconnect power, slightly loosen the knob or, on this top-post model, completely remove the knob to discourage unauthorized use while stored at home, parked, or when traveling.
use with 700R4 or 2004R automatic trans. EXCEPT 4L60E or 4L80E. Completely externally installed kit... see moreuse with 700R4 or 2004R automatic trans. EXCEPT 4L60E or 4L80E. Completely externally installed kit allows for automatic operation of the torque converter lock-up (overdrive) without installing the computer!!!! Kit includes instructions.