BATTERY CABLE

Frequently Bought Together

• 

  BATTERY BUTLER – BATTERY STORAGE CHARGER: 6/12 volt

  Keeps your battery fully charged and maintained to extend battery life. Monitoring circuitry automatically turns... see moreKeeps your battery fully charged and maintained to extend battery life. Monitoring circuitry automatically turns charger on & off as needed. Fully protected against overcharging, short circuits, and reverse polarity. Features red/green LED indicator light status. Includes both clamp and fused ring-terminal connection adapters. Works on all 6 or 12 volt lead-acid Wet/AGM/Gel batteries. Plug charger it into any 110 volt socket, connect to your battery, and forget about it!

  Part #: BBFC100

  $24.95 Add to cart View Details
• 

  BATTERY BUTLER – BATTERY STORAGE CHARGER: 6 VOLT

  Prevents the self-discharge of your 6 volt battery, while maintaining and extending battery life. Solid... see morePrevents the self-discharge of your 6 volt battery, while maintaining and extending battery life. Solid State circuitry will keep your battery safely and fully charged, without fear of overcharging. Features separate power and charging LED indicators. Plug it into any 110 volt wall socket, hook it up to your 6 volt battery, and forget about it until you're ready to roll again!!!

  Part #: BBFC200

  $5.00 Add to cart View Details
• 

  TERMINAL REMOVAL TOOL

  blade width .08". If you need to remove a metal terminal from its plastic connector,... see moreblade width .08". If you need to remove a metal terminal from its plastic connector, this genuine Aptive/Delphi tool allows you to depress & release the locking tang on most terminals used by GM from 1950-80s. Not for use with Weather-Pak terminals. Made in USA.

  Part #: 12094430

  $14.00 Add to cart View Details
• 

  WIRE HARNESS MODIFICATION: CONVERSION TO H.E.I.

  GM H.E.I. (High Energy Ignition) style distributor. Order the correct harness part # for your... see moreGM H.E.I. (High Energy Ignition) style distributor. Order the correct harness part # for your car along with this modification part #. The harness you need to order is usually the Engine Harness, but can be the Dash Harness. To verify, check the wiring going to the ignition coil and ballast resistor (if applicable) in your car.

  Part #: 34590

  $69.00 Add to cart View Details