This handy cut-off switch lets you quickly and easily disconnect your battery for safety when servicing your vehicle or in storage, to eliminate battery drain while vehicle is not in use, and for security as an anti-theft device. Install on the negative post of your battery, attach battery cable to the switch and you’re done! To engage power close the lever (made of quality solid copper). To disconnect power open the lever.
Additional information
Lectric Limited Part #
BBDC301
WebID Part #
id-bbdc301-0030
Weight
0.5 lbs
You have not selected a vehicle
Also fits*:* This fit is only a guideline. Please verify the fit by entering your specific vehicle.
This device eliminates battery drain while vehicle is in storage by disconnecting your battery from devices that continuously draw power.
Safety When Servicing Your Vehicle: - With battery cable disconnected, you can safely work on your vehicle without the worry of sparks or short circuit. - Eliminates the chance of damaging expensive electrical or computerized equipment.
Anti-Theft Device: - You can't start a car without battery power! - Inexpensive & reliable.
Easy To Install: 1. Remove the negative battery cable from your battery. 2. Install switch on the negative battery post. 3. Attach battery cable to the switch, and you're done!
Easy To Use: - Once installed, requires no tools to disconnect battery. - To disconnect battery power or discourage unauthorized use while vehicle is stored, parked, or when traveling, simply open the lever. - To engage power, just close the lever.
Heavy-Duty Rated: - For 6-24 volt batteries. - Rated to 250 amps continuous or 750 amps surge at 12 volts. - Made with a quality, solid copper knife-blade. Note: These battery disconnects are designed to be used with only 1 battery. Semi-trucks, some commercial equipment, or vehicles that use multiple batteries, will require additional disconnects.
Car Show Judge Approved: For show car owners concerned about judging, these quick-disconnects are accepted by most, if not all, car show judges as a necessary safety feature. Some judging standards actually award points to those using our quick-disconnect switches. For example, the N.C.R.S. (National Corvette Restorer's Society) will award you 3 points!
Prevents the self-discharge of your 6 volt battery, while maintaining and extending battery life. Solid... see morePrevents the self-discharge of your 6 volt battery, while maintaining and extending battery life. Solid State circuitry will keep your battery safely and fully charged, without fear of overcharging. Features separate power and charging LED indicators. Plug it into any 110 volt wall socket, hook it up to your 6 volt battery, and forget about it until you're ready to roll again!!!
1" black high temperature, adhesive, 100 ft. roll, Note: This is high temperature tape, commonly... see more1" black high temperature, adhesive, 100 ft. roll, Note: This is high temperature tape, commonly used on Transistor Ignition Harnesses or on parts of harnesses which route in areas exposed to high temperatures, near exhaust manifolds, over intake manifolds, etc.
front single dash speaker, with manual radio (wiring from inside radio to speaker) Use when... see morefront single dash speaker, with manual radio (wiring from inside radio to speaker) Use when installing original, replacement, or aftermarket speaker. Made with correct connector for hook-up to current GM replacement speaker and correct connector for connection to original radio or rear speaker fader switch wiring. You can cut off connector for hook-up to current GM replacement speaker and solder wires directly to original speaker (as was done originally) or aftermarket speaker.