internal circuit board to Engine Harness NOTE: This part shown for reference only. It is NOT available.
Additional information
Lectric Limited Part #
N/A
WebID Part #
id-n/a-1155
Weight
0.0 lbs
You have not selected a vehicle
TECH NOTES:
The C.D. Ignition Amplifier Box Extension is the short wiring that goes from the internal circuit board (inside the T.I. box) to the Engine Harness. Basically, it is the wiring from the amplifier box.
Similar features as the knob type top post version, but designed for side post batteries.Similar features as the knob type top post version, but designed for side post batteries.
Keeps your battery fully charged and maintained to extend battery life. Monitoring circuitry automatically turns... see moreKeeps your battery fully charged and maintained to extend battery life. Monitoring circuitry automatically turns charger on & off as needed. Fully protected against overcharging, short circuits, and reverse polarity. Features red/green LED indicator light status. Includes both clamp and fused ring-terminal connection adapters. Works on all 6 or 12 volt lead-acid Wet/AGM/Gel batteries. Plug charger it into any 110 volt socket, connect to your battery, and forget about it!
GM H.E.I. (High Energy Ignition) style distributor. Order the correct harness part # for your... see moreGM H.E.I. (High Energy Ignition) style distributor. Order the correct harness part # for your car along with this modification part #. The harness you need to order is usually the Engine Harness, but can be the Dash Harness. To verify, check the wiring going to the ignition coil and ballast resistor (if applicable) in your car.
Valid at www.LectricLimited.com. Valid on online orders only, not phone-in orders. See "Tech Notes "... see moreValid at www.LectricLimited.com. Valid on online orders only, not phone-in orders. See "Tech Notes " for details.