-O.E.M. made in U.S.A. using original GM tooling-, V8, Chevrolet 267 & 305 C.I.
Additional information
Lectric Limited Part #
17061769
OEM Part #
17061769
WebID Part #
id-17061769-0019
Weight
0.4 lbs
You have not selected a vehicle
Also fits*:* This fit is only a guideline. Please verify the fit by entering your specific vehicle.
Make
Model
Years
CHEVROLET
TRUCK/PICK-UP/SUBURBAN/BLAZER
1978
CHEVROLET
CORVETTE
1977 - 1980
CHEVROLET
CAMARO
1977 - 1981
CHEVROLET
CHEVELLE/EL CAMINO/MONTE CARLO/MALIBU
1977 - 1981
CHEVROLET
CHEVY II/NOVA
1977 - 1981
CHEVROLET
FULLSIZE 1958 & UP
1977 - 1981
OLDSMOBILE
CUTLASS/442/F-85
1978
PONTIAC
TEMPEST/LEMANS/GTO/T-37/GRAND AM/VENTURA
1978 - 1981
PONTIAC
FIREBIRD/TRANS AM
1978 - 1981
PONTIAC
FULLSIZE/GRAND PRIX
1978 - 1981
TECH NOTES:
The Carburetor Idle Stop Solenoid is an electromagnetic device mounted on carburetor linkage that maintains the proper throttle opening for a specified idle speed while the ignition is on, but allows the throttle to close farther when the ignition is switched off. This shuts off the engine's air supply to prevent engine run-on.
This handy cut-off switch lets you quickly and easily disconnect your battery for safety when... see moreThis handy cut-off switch lets you quickly and easily disconnect your battery for safety when servicing your vehicle or in storage, to eliminate battery drain while vehicle is not in use, and for security as an anti-theft device. Install on the negative post of your battery, attach battery cable to the switch and you're done! To engage power just hand tighten the green knob. To disconnect power, slightly loosen the knob or, on this top-post model, completely remove the knob to discourage unauthorized use while stored at home, parked, or when traveling.
blade width .04". If you need to remove a metal terminal from its plastic connector,... see moreblade width .04". If you need to remove a metal terminal from its plastic connector, this genuine Aptive/Delphi tool allows you to depress & release the locking tang on most terminals used by GM from 1950-80s. Not for use with Weather-Pak terminals. Made in USA.
power feed & speaker out for original Delco radio, (includes 3 connectors and pigtails)power feed & speaker out for original Delco radio, (includes 3 connectors and pigtails)
rear speaker, (wiring from speaker to speaker harness connector, 1 required per speaker) Use when... see morerear speaker, (wiring from speaker to speaker harness connector, 1 required per speaker) Use when installing aftermarket speakers. Made to solder wires directly to aftermarket speaker and with correct connector for connection to original wiring.