-O.E.M. made in Mexico-, all with “0202” printed on lower right of fuse block next to turn signal flasher (30 amp inserts into fuse block) ****NOTE: THESE CARS USED A 30 AMP FUSE LOCATED IN THE CAVITY MARKED “DEFOG” ON LOWER RIGHT PORTION OF THE FUSE BLOCK****
Additional information
Lectric Limited Part #
01252240
OEM Part #
01252240
WebID Part #
id-01252240-0004
Weight
0.1 lbs
You have not selected a vehicle
Also fits*:* This fit is only a guideline. Please verify the fit by entering your specific vehicle.
Make
Model
Years
BUICK
FULLSIZE/RIVIERA
1979 - 1981
BUICK
SKYLARK/SPECIAL/GRAN SPORT
1979 - 1981
CADILLAC
FLEETWOOD/SEVILLE/DEVILLE/EL DORADO
1977 - 1981
CHEVROLET
CAMARO
1980 - 1981
CHEVROLET
CHEVELLE/EL CAMINO/MONTE CARLO/MALIBU
1979 - 1981
CHEVROLET
CORVETTE
1979 - 1982
CHEVROLET
FULLSIZE 1958 & UP
1979 - 1981
CHEVROLET
TRUCK/PICK-UP/SUBURBAN/BLAZER
1979 - 1984
GMC
TRUCK
1979 - 1984
OLDSMOBILE
CUTLASS/442/F-85
1979 - 1981
OLDSMOBILE
FULLSIZE
1979 - 1981
OLDSMOBILE
TORONADO
1979 - 1981
PONTIAC
FULLSIZE/GRAND PRIX
1979 - 1981
PONTIAC
TEMPEST/LEMANS/GTO/T-37/GRAND AM/VENTURA
1979 - 1981
TECH NOTES:
A Circuit Breaker protects the wiring harness in case of an overload or short circuit from various power accessories.
Lectric Limited's circuit breakers have the correct amperage rating as specified by the vehicle's manufacturer.
This handy cut-off switch lets you quickly and easily disconnect your battery for safety when... see moreThis handy cut-off switch lets you quickly and easily disconnect your battery for safety when servicing your vehicle or in storage, to eliminate battery drain while vehicle is not in use, and for security as an anti-theft device. Install on the negative post of your battery, attach battery cable to the switch and you're done! To engage power just hand tighten the green knob. To disconnect power, slightly loosen the knob or, on this top-post model, completely remove the knob to discourage unauthorized use while stored at home, parked, or when traveling.
12 VOLT, After simple installation of this kit your courtesy lamps will remain on for... see more12 VOLT, After simple installation of this kit your courtesy lamps will remain on for a user adjustable amount of time (0-60 seconds), or until the ignition switch is turned to on or accessory. At the end of the delay function, the courtesy lights will gradually fade to dark.
Same features as the knife-blade type top post version, but designed for side post batteries.Same features as the knife-blade type top post version, but designed for side post batteries.