with factory console gauges, without seat belt warning buzzer
Additional information
Lectric Limited Part #
16830
OEM Part #
08909946
WebID Part #
id-16830-0001
Weight
4.0 lbs
You have not selected a vehicle
Also fits*:* This fit is only a guideline. Please verify the fit by entering your specific vehicle.
Make
Model
Years
CHEVROLET
CHEVY II/NOVA
1972
TECH NOTES:
SEAT BELT WARNING BUZZER It is important to identify if your 1972 vehicle came from the factory with, or without the seat belt warning buzzer to avoid problems when rewiring your vehicle. Do not assume that because you don't hear the buzzer, that your vehicle did not come with one. This buzzer was often removed because the sound was annoying.
1972 introduced the seat belt warning buzzer to all GM vehicles. This buzzer was designed to audibly remind drivers to fasten their seat belt.
Some early 1972 production vehicles did not have a seat belt warning system.
Other early 1972 production vehicles used the following to control the seat belt warning system: * Indicator Lamp (illuminated for a few seconds) * Timer (located behind dash)
If your vehicle is setup this way, you should purchase the Dash Harness, Rear Body Harness, and/or other electrical items for the "WITHOUT seat belt warning buzzer" application.
Note: MOST 1972 production vehicles used the following to control the seat belt warning system: * Indicator Lamp (illuminated until seat belt pulled from retractor) * Warning Buzzer (located behind dash, sounded until seat belt pulled from retractor) * (1) Seat Switch (located in passenger side seat cushion) * (2) Seat Belt Retractor Switches (located in each front seat belt retractor)
If your vehicle is setup this way, you should purchase the Dash Harness, Rear Body Harness, and/or other electrical items for the "WITH seat belt warning buzzer" application.
-reproduction-, V8 (mounts to coil bracket, connects to positive post on coil)-reproduction-, V8 (mounts to coil bracket, connects to positive post on coil)
-original 1/2 x 14 N.P.T.F.-, with factory console gauges (correct resistance and connection, produces accurate... see more-original 1/2 x 14 N.P.T.F.-, with factory console gauges (correct resistance and connection, produces accurate gauge display)
Keeps your battery fully charged and maintained to extend battery life. Monitoring circuitry automatically turns... see moreKeeps your battery fully charged and maintained to extend battery life. Monitoring circuitry automatically turns charger on & off as needed. Fully protected against overcharging, short circuits, and reverse polarity. Features red/green LED indicator light status. Includes both clamp and fused ring-terminal connection adapters. Works on all 6 or 12 volt lead-acid Wet/AGM/Gel batteries. Plug charger it into any 110 volt socket, connect to your battery, and forget about it!
20-14 gauge terminal crimper, not intended for use with Weather-Pak or Metri-Pac terminals requiring rubber... see more20-14 gauge terminal crimper, not intended for use with Weather-Pak or Metri-Pac terminals requiring rubber seals