all automatic transmission, 1st design: VIN ending in 00001 to 27372, alarm switch located in driver side front fender & alarm horn located behind driver side rear fender
Additional information
Lectric Limited Part #
VMA7700AT
OEM Part #
08916432
WebID Part #
id-vma7700at-0001
Weight
4.9 lbs
You have not selected a vehicle
Also fits*:* This fit is only a guideline. Please verify the fit by entering your specific vehicle.
Make
Model
Years
CHEVROLET
CORVETTE
1977
TECH NOTES:
Distinguishing between 1st and 2nd Design 1977 Corvettes.
Shown below is information regarding 1977 (2nd Design) Corvettes as shown in Chevrolet Dealer Service Bulletin 77-I-38, Section XII, Dated May 1977:
Subject: Anti-Theft Alarm System Interim Modifications
Several modifications to the 1977 Corvette anti-theft alarm system were introduced into production effective March 21, 1977 with VIN 1Z37X7S427373.
(2nd Design) modifications are as follows: - The actuating switch for the alarm system is no longer located on the left (driver's side) front fender. It has been incorporated into the left front door lock and must be activated by locking this door with the key from the outside of the vehicle. This is the *ONLY* way the alarm can be set. Turning the inside knob to the locked position when exiting the vehicle *WILL NOT* activate the alarm system.
- The anti-theft alarm system horn has been moved from the left (driver's side) rear inner fender to the far left side (driver's side) of the engine compartment dash panel.
- The anti-theft alarm system flasher assembly is now located on the console trim plate, rather than the rear compartment underbody panel.
- The new anti-theft alarm system wiring diagram has been modified to reflect these changes.
Chevrolet Motor Division General Motors Corporation
all (mounts inside distributor, includes terminal block, correct wires, connectors, and radio capacitor) Note: This... see moreall (mounts inside distributor, includes terminal block, correct wires, connectors, and radio capacitor) Note: This is the improved 1978-91 style part that is a direct replacement for the original style Distributor Module to Coil Harness. TOTALLY STOCK APPEARANCE WITH DISTRIBUTOR CAP INSTALLED!!
all 2nd design: VIN ending in 27373 to 49213, alarm switch located in driver side... see moreall 2nd design: VIN ending in 27373 to 49213, alarm switch located in driver side door lock cylinder & alarm horn located behind driver side front fender, near firewall Note: Requires use of VPL7778 to complete wiring to front parking/turn signal lights
all manual transmission, 1st design: VIN ending in 00001 to 27372, alarm switch located in... see moreall manual transmission, 1st design: VIN ending in 00001 to 27372, alarm switch located in driver side front fender & alarm horn located behind driver side rear fender