all manual transmission, 1st design: VIN ending in 00001 to 27372, alarm switch located in driver side front fender & alarm horn located behind driver side rear fender
Additional information
Lectric Limited Part #
VMA7700MT
OEM Part #
08916433
WebID Part #
id-vma7700mt-0001
Weight
4.6 lbs
You have not selected a vehicle
Also fits*:* This fit is only a guideline. Please verify the fit by entering your specific vehicle.
Make
Model
Years
CHEVROLET
CORVETTE
1977
TECH NOTES:
Distinguishing between 1st and 2nd Design 1977 Corvettes.
Shown below is information regarding 1977 (2nd Design) Corvettes as shown in Chevrolet Dealer Service Bulletin 77-I-38, Section XII, Dated May 1977:
Subject: Anti-Theft Alarm System Interim Modifications
Several modifications to the 1977 Corvette anti-theft alarm system were introduced into production effective March 21, 1977 with VIN 1Z37X7S427373.
(2nd Design) modifications are as follows: - The actuating switch for the alarm system is no longer located on the left (driver's side) front fender. It has been incorporated into the left front door lock and must be activated by locking this door with the key from the outside of the vehicle. This is the *ONLY* way the alarm can be set. Turning the inside knob to the locked position when exiting the vehicle *WILL NOT* activate the alarm system.
- The anti-theft alarm system horn has been moved from the left (driver's side) rear inner fender to the far left side (driver's side) of the engine compartment dash panel.
- The anti-theft alarm system flasher assembly is now located on the console trim plate, rather than the rear compartment underbody panel.
- The new anti-theft alarm system wiring diagram has been modified to reflect these changes.
Chevrolet Motor Division General Motors Corporation
-replacement made in Taiwan-, all Replaces flasher #'s 142, 143, 144, 145, 223, 224, 323,... see more-replacement made in Taiwan-, all Replaces flasher #'s 142, 143, 144, 145, 223, 224, 323, AP273, AP373, SF224, SF323, SF323YB, ZN232, and ZN332. Will flash turn signals at the correct rate, unlike other aftermarket flashers!! (has a silver round metal housing)
-reproduction-, all 1st design: VIN ending in 00001 to 27372, alarm switch located in fender... see more-reproduction-, all 1st design: VIN ending in 00001 to 27372, alarm switch located in fender (includes light bulb & Under Hood Light Ground Wire)
(wiring from speaker to speaker harness connector, 2 required per car) Use when installing original,... see more(wiring from speaker to speaker harness connector, 2 required per car) Use when installing original, replacement, or aftermarket speakers. Made with correct connector for hook-up to current GM replacement speaker and correct connector for connection to original wiring, or cut off connector for hook-up to current GM replacement speaker and solder wires directly to original speaker (as was done originally) or aftermarket speaker.