rear of door, -reproduction-, all 1st design: 3 wires connect to each door ajar switch, each switch has 3 holes in a plastic insulator to accept pin type terminals on wires from harness (2 required per car) ****(IT IS HIGHLY RECOMMENDED TO PURCHASE NEW TERMINALS WHEN REPLACING THESE SWITCHES)****
Additional information
Lectric Limited Part #
03929804
OEM Part #
03929804
WebID Part #
id-03929804-0004
Weight
0.1 lbs
You have not selected a vehicle
Also fits*:* This fit is only a guideline. Please verify the fit by entering your specific vehicle.
Make
Model
Years
CHEVROLET
CORVETTE
1968 - 1974
TECH NOTES:
Our switch is manufactured per the original GM blueprint specifications and utilizes a 3/8"-24 Type "C" thread. Per GM specifications, our switch is designed to cut its own threads when installed into a .348" diameter non-threaded hole in the switch mounting/backing plate.
Our switch should easily fit, and screw into an original mounting/backing plate.
However, it has come to our attention that there my be problems when installing our switch into some (or all) of the currently reproduced mounting/backing plates. The reason is that these reproduction mounting/backing plates have a smaller hole size and are pre-threaded.
1" black high temperature, adhesive, 100 ft. roll, Note: This is high temperature tape, commonly... see more1" black high temperature, adhesive, 100 ft. roll, Note: This is high temperature tape, commonly used on Transistor Ignition Harnesses or on parts of harnesses which route in areas exposed to high temperatures, near exhaust manifolds, over intake manifolds, etc.
with H.E.I. coil on distributor This harness will allow you to easily replace your mechanical... see morewith H.E.I. coil on distributor This harness will allow you to easily replace your mechanical cable driven tachometer with a 1975-77 electric tachometer without cutting or splicing any wiring. Does not include tachometer or tachometer filter (which may be required for correct operation).