Also fits*:* This fit is only a guideline. Please verify the fit by entering your specific vehicle.
Make
Model
Years
PONTIAC
TEMPEST/LEMANS/GTO/T-37/GRAND AM/VENTURA
1964
TECH. NOTES:
What is General Motors' C.A.C. A/C?
Cars of this era were either manufactured with:
- C.A.C. C.A.C. stood for "Cool Air Comfort" fresh air ventilation only. This ventilation system used a manually-operated slider cable to open/close a ventilation door near the floorboard. There is no wiring involved with C.A.C. only cars. C.A.C. could either be ordered separately without air-conditioning, or it came automatically installed on all factory-installed A/C cars of that era.)
- C.A.C. A/C. This meant C.A.C. + optional factory installed "Basic" air-conditioning. "Basic" air-conditioning meant that it was not a user-settable temperature / climate controlled air-conditioning like the trade named Comfortron or Circ-L-Aire (for example).
- COMFORTRON, CIRC-L-AIRE, or other user-settable temperature / climate control A/C systems. These were factory installed air-conditioning systems, only installed on fullsize cars, and were a RARE factory option.
- COOL PACK A/C. This was an optional under dash air-conditioning unit, usually dealer installed. Lectric Limited does not manufacture the wiring for the Cool Pack A/C system itself. However, if you have the Cool Pack A/C system, you can buy the Lectric Limited wiring for a non-A/C car, and re-use your original wiring from the dealer-installed Cool Pack A/C.
This handy cut-off switch lets you quickly and easily disconnect your battery for safety when... see moreThis handy cut-off switch lets you quickly and easily disconnect your battery for safety when servicing your vehicle or in storage, to eliminate battery drain while vehicle is not in use, and for security as an anti-theft device. Install on the negative post of your battery, attach battery cable to the switch and you're done! To engage power just hand tighten the green knob. To disconnect power, slightly loosen the knob or, on this top-post model, completely remove the knob to discourage unauthorized use while stored at home, parked, or when traveling.
fader switch assembly to radio & rear speaker wire, with front single dash speaker &... see morefader switch assembly to radio & rear speaker wire, with front single dash speaker & rear speaker, without reverb (solders directly to terminals on fader switch assembly)
Keeps your battery fully charged and maintained to extend battery life. Monitoring circuitry automatically turns... see moreKeeps your battery fully charged and maintained to extend battery life. Monitoring circuitry automatically turns charger on & off as needed. Fully protected against overcharging, short circuits, and reverse polarity. Features red/green LED indicator light status. Includes both clamp and fused ring-terminal connection adapters. Works on all 6 or 12 volt lead-acid Wet/AGM/Gel batteries. Plug charger it into any 110 volt socket, connect to your battery, and forget about it!