ENGINE HARNESS

Frequently Bought Together

• 

  FLASHER: TURN SIGNAL

  -replacement made in Taiwan-, Replaces 12 volt flasher #'s 142, 143, 144, 145, 223, 224,... see more-replacement made in Taiwan-, Replaces 12 volt flasher #'s 142, 143, 144, 145, 223, 224, 323, AP273, AP373, SF224, SF323, SF323YB, ZN232, and ZN332. Will flash turn signals at the correct rate, unlike other aftermarket flashers!! (has a silver round metal housing)

  Part #: 90491392

  $12.00 Add to cart View Details
• 

  BATTERY BUTLER – BATTERY STORAGE CHARGER: 6/12 volt

  Keeps your battery fully charged and maintained to extend battery life. Monitoring circuitry automatically turns... see moreKeeps your battery fully charged and maintained to extend battery life. Monitoring circuitry automatically turns charger on & off as needed. Fully protected against overcharging, short circuits, and reverse polarity. Features red/green LED indicator light status. Includes both clamp and fused ring-terminal connection adapters. Works on all 6 or 12 volt lead-acid Wet/AGM/Gel batteries. Plug charger it into any 110 volt socket, connect to your battery, and forget about it!

  Part #: BBFC100

  $24.95 Add to cart View Details
• 

  BATTERY QUICK-DISCONNECT KNIFE-BLADE TYPE: TOP POST BATTERY

  This handy cut-off switch lets you quickly and easily disconnect your battery for safety when... see moreThis handy cut-off switch lets you quickly and easily disconnect your battery for safety when servicing your vehicle or in storage, to eliminate battery drain while vehicle is not in use, and for security as an anti-theft device. Install on the negative post of your battery, attach battery cable to the switch and you're done! To engage power close the lever (made of quality solid copper). To disconnect power open the lever.

  Part #: BBDC301

  $39.00 Add to cart View Details
• 

  TERMINAL REMOVAL TOOL

  blade width .08". If you need to remove a metal terminal from its plastic connector,... see moreblade width .08". If you need to remove a metal terminal from its plastic connector, this genuine Aptive/Delphi tool allows you to depress & release the locking tang on most terminals used by GM from 1950-80s. Not for use with Weather-Pak terminals. Made in USA.

  Part #: 12094430

  $14.00 Add to cart View Details