Also fits*:* This fit is only a guideline. Please verify the fit by entering your specific vehicle.
Make
Model
Years
CHEVROLET
CORVETTE
1957
CONNECTS TO: - Ammeter Gauge Terminal (passenger side) - Electric Choke Connection - Generator (armature terminal, early production cars built before 4/1957) - Ignition Ballast Resistor - Ignition Ballast Resistor (driver side screw terminal, late production cars built after 4/1957) - Ignition Coil ("+" terminal) - Ignition Switch - Ignition Switch ("Batt" terminal) - Starter Solenoid - Temperature Gauge (passenger side terminal) - Temperature Sending Unit
-replacement made in Taiwan-, all Replaces flasher #'s 142, 143, 144, 145, 223, 224, 323,... see more-replacement made in Taiwan-, all Replaces flasher #'s 142, 143, 144, 145, 223, 224, 323, AP273, AP373, SF224, SF323, SF323YB, ZN232, and ZN332. Will flash turn signals at the correct rate, unlike other aftermarket flashers!! (has a silver round metal housing)
This handy cut-off switch lets you quickly and easily disconnect your battery for safety when... see moreThis handy cut-off switch lets you quickly and easily disconnect your battery for safety when servicing your vehicle or in storage, to eliminate battery drain while vehicle is not in use, and for security as an anti-theft device. Install on the negative post of your battery, attach battery cable to the switch and you're done! To engage power just hand tighten the green knob. To disconnect power, slightly loosen the knob or, on this top-post model, completely remove the knob to discourage unauthorized use while stored at home, parked, or when traveling.
Flaming River or 1977 & later GM column to stock Dash Harness, Note: Adapts horn,... see moreFlaming River or 1977 & later GM column to stock Dash Harness, Note: Adapts horn, directionals, & 4 way flashers of column to stock 1953-62 dash connector