service replacement, all without factory air conditioning: for use with alternator, voltage regulator, and horn relay re-located from passenger side to driver side
Additional information
Lectric Limited Part #
VIG6365SR
OEM Part #
02989479
WebID Part #
id-vig6365sr-0006
Weight
1.6 lbs
You have not selected a vehicle
Also fits*:* This fit is only a guideline. Please verify the fit by entering your specific vehicle.
Make
Model
Years
CHEVROLET
CORVETTE
1963 - 1965
CONNECTS TO: - Alternator - Automatic Transmission (when applies) - Blower Motor (with aftermarket A/C) - Blower Motor Ground Terminal (with aftermarket A/C) - Dash Harness Connection (at firewall) - Ground (to horn relay mounting bolt) - Ground (to starter motor mounting bolt) - Ground (to voltage regulator mounting bolt) - Horn (driver & passenger side) - Horn Relay - Ignition Ballast Resistor (top screw terminal) - Ignition Coil ("+" terminal) - Starter Solenoid - Temperature Sending Unit - Voltage Regulator - Windshield Wiper Motor Ground Terminal
ATO/ATC "standard" blade, Troubleshoot your electrical system, pinpoint electrical issues, and skip the hassle of... see moreATO/ATC "standard" blade, Troubleshoot your electrical system, pinpoint electrical issues, and skip the hassle of replacing blown fuses. Features a manual push-button reset allowing you to restore power quickly once the issue is found. This circuit breaker set includes 3, 5, 7.5, 10, 15, 20, 25, and 30 amp ratings.
This handy cut-off switch lets you quickly and easily disconnect your battery for safety when... see moreThis handy cut-off switch lets you quickly and easily disconnect your battery for safety when servicing your vehicle or in storage, to eliminate battery drain while vehicle is not in use, and for security as an anti-theft device. Install on the negative post of your battery, attach battery cable to the switch and you're done! To engage power close the lever (made of quality solid copper). To disconnect power open the lever.
20-14 gauge terminal crimper, not intended for use with Weather-Pak or Metri-Pac terminals requiring rubber... see more20-14 gauge terminal crimper, not intended for use with Weather-Pak or Metri-Pac terminals requiring rubber seals
Keeps your battery fully charged and maintained to extend battery life. Monitoring circuitry automatically turns... see moreKeeps your battery fully charged and maintained to extend battery life. Monitoring circuitry automatically turns charger on & off as needed. Fully protected against overcharging, short circuits, and reverse polarity. Features red/green LED indicator light status. Includes both clamp and fused ring-terminal connection adapters. Works on all 6 or 12 volt lead-acid Wet/AGM/Gel batteries. Plug charger it into any 110 volt socket, connect to your battery, and forget about it!