service replacement, all small block with AFTERMARKET air conditioning: for use with alternator, voltage regulator, and horn relay re-located from passenger side to driver side
Additional information
Lectric Limited Part #
VIG6365SR
OEM Part #
02989479
WebID Part #
id-vig6365sr-0004
Weight
1.6 lbs
You have not selected a vehicle
Also fits*:* This fit is only a guideline. Please verify the fit by entering your specific vehicle.
Make
Model
Years
CHEVROLET
CORVETTE
1963 - 1965
CONNECTS TO: - Alternator - Automatic Transmission (when applies) - Blower Motor (with aftermarket A/C) - Blower Motor Ground Terminal (with aftermarket A/C) - Dash Harness Connection (at firewall) - Ground (to horn relay mounting bolt) - Ground (to starter motor mounting bolt) - Ground (to voltage regulator mounting bolt) - Horn (driver & passenger side) - Horn Relay - Ignition Ballast Resistor (top screw terminal) - Ignition Coil ("+" terminal) - Starter Solenoid - Temperature Sending Unit - Voltage Regulator - Windshield Wiper Motor Ground Terminal
all (includes pair of pre-assembled light sockets, tubing, wiring, & correct molded connectors) NOTE: Designed... see moreall (includes pair of pre-assembled light sockets, tubing, wiring, & correct molded connectors) NOTE: Designed to replace only the light sockets and wiring. Original front parking/turn signal light assembly was comprised of a bezel/housing with a non-removable light socket and wiring. Customer must decide best method to remove the old, then re-attach the new, light socket to bezel/housing.
service replacement, all small block without factory air conditioning: for use with alternator, voltage regulator,... see moreservice replacement, all small block without factory air conditioning: for use with alternator, voltage regulator, and horn relay re-located from passenger side to driver side
all (wiring from radio to speaker) Use when installing original, replacement, or aftermarket speakers. Made... see moreall (wiring from radio to speaker) Use when installing original, replacement, or aftermarket speakers. Made with correct connector for hook-up to current GM replacement speaker and correct connector for connection to original wiring, or cut off connector for hook-up to current GM replacement speaker and solder wires directly to original speaker (as was done originally) or aftermarket speaker
blade width .08". If you need to remove a metal terminal from its plastic connector,... see moreblade width .08". If you need to remove a metal terminal from its plastic connector, this genuine Aptive/Delphi tool allows you to depress & release the locking tang on most terminals used by GM from 1950-80s. Not for use with Weather-Pak terminals. Made in USA.