1" black high temperature, adhesive, 100 ft. roll, Note: This is high temperature tape, commonly... see more1" black high temperature, adhesive, 100 ft. roll, Note: This is high temperature tape, commonly used on Transistor Ignition Harnesses or on parts of harnesses which route in areas exposed to high temperatures, near exhaust manifolds, over intake manifolds, etc.
This wire will replace both the resistance wire and starter solenoid-to-coil wire (to install a... see moreThis wire will replace both the resistance wire and starter solenoid-to-coil wire (to install a GM H.E.I. distributor, an ignition system crank/start resistance by-pass is required)
Keeps your battery fully charged and maintained to extend battery life. Monitoring circuitry automatically turns... see moreKeeps your battery fully charged and maintained to extend battery life. Monitoring circuitry automatically turns charger on & off as needed. Fully protected against overcharging, short circuits, and reverse polarity. Features red/green LED indicator light status. Includes both clamp and fused ring-terminal connection adapters. Works on all 6 or 12 volt lead-acid Wet/AGM/Gel batteries. Plug charger it into any 110 volt socket, connect to your battery, and forget about it!
fuse block to windshield wiper switch bezel, This wire allows you to add a light... see morefuse block to windshield wiper switch bezel, This wire allows you to add a light to your windshield wiper switch, as used on 1973-76, without cutting or splicing any wiring. Intended for use with, but does not include, a 1973-76 windshield wiper switch bezel. (Includes light bulb)