all T.H. 350C locking torque converter automatic transmission (MV4 option code) (includes A/C wiring) Note: Requires use of a Starter Motor Extension Harness to complete wiring to starter solenoid.
Additional information
Lectric Limited Part #
VIG8000CA
OEM Part #
12005835
WebID Part #
id-vig8000ca-0001
Weight
2.5 lbs
You have not selected a vehicle
Also fits*:* This fit is only a guideline. Please verify the fit by entering your specific vehicle.
Make
Model
Years
CHEVROLET
CORVETTE
1980
CONNECTS TO: - Air Conditioning Relay - Blower Motor - Blower Motor Ground Terminal - Blower Motor Resistor - Compressor Clutch Switch - Compressor Cycling Switch (located on accumulator/dryer) - Dash Harness Connection (at firewall) - Hood Ajar Switch - Ignition Coil (on distributor) - Oil Pressure Sender Wire Connection - Radiator Cooling Fan Harness Connection (L-82 engines only) - Starter Motor Extension Harness Connection - Tachometer Filter Connection - Torque Converter Clutch Harness Connection - Torque Converter Lockup Switch (located on firewall) - Windshield Washer Pump - Windshield Wiper Motor - Windshield Wiper Motor Cover Connection - Windshield Wiper Motor Ground Terminal
This handy cut-off switch lets you quickly and easily disconnect your battery for safety when... see moreThis handy cut-off switch lets you quickly and easily disconnect your battery for safety when servicing your vehicle or in storage, to eliminate battery drain while vehicle is not in use, and for security as an anti-theft device. Install on the negative post of your battery, attach battery cable to the switch and you're done! To engage power just hand tighten the green knob. To disconnect power, slightly loosen the knob or, on this top-post model, completely remove the knob to discourage unauthorized use while stored at home, parked, or when traveling.
simple plug-in conversion allows use of a 1984-99 CS external fan series, internally regulated alternator... see moresimple plug-in conversion allows use of a 1984-99 CS external fan series, internally regulated alternator in place of the original SI series internally regulated alternator
This harness will allow you to easily replace your clock with a 1981-82 oil temperature... see moreThis harness will allow you to easily replace your clock with a 1981-82 oil temperature gauge and sending unit without cutting or splicing any wiring. Intended for use with, but does not include, the original style oil temperature gauge and sending unit.