all T.H. 350C locking torque converter automatic transmission (MV4 option code) (includes A/C wiring) Note: Requires use of a Starter Motor Extension Harness to complete wiring to starter solenoid.
Additional information
Lectric Limited Part #
VIG8000CA
OEM Part #
12005835
WebID Part #
id-vig8000ca-0001
Weight
2.5 lbs
You have not selected a vehicle
Also fits*:* This fit is only a guideline. Please verify the fit by entering your specific vehicle.
Make
Model
Years
CHEVROLET
CORVETTE
1980
CONNECTS TO: - Air Conditioning Relay - Blower Motor - Blower Motor Ground Terminal - Blower Motor Resistor - Compressor Clutch Switch - Compressor Cycling Switch (located on accumulator/dryer) - Dash Harness Connection (at firewall) - Hood Ajar Switch - Ignition Coil (on distributor) - Oil Pressure Sender Wire Connection - Radiator Cooling Fan Harness Connection (L-82 engines only) - Starter Motor Extension Harness Connection - Tachometer Filter Connection - Torque Converter Clutch Harness Connection - Torque Converter Lockup Switch (located on firewall) - Windshield Washer Pump - Windshield Wiper Motor - Windshield Wiper Motor Cover Connection - Windshield Wiper Motor Ground Terminal
all (mounts inside distributor, includes terminal block, correct wires, connectors, and radio capacitor)all (mounts inside distributor, includes terminal block, correct wires, connectors, and radio capacitor)
blade width .08". If you need to remove a metal terminal from its plastic connector,... see moreblade width .08". If you need to remove a metal terminal from its plastic connector, this genuine Aptive/Delphi tool allows you to depress & release the locking tang on most terminals used by GM from 1950-80s. Not for use with Weather-Pak terminals. Made in USA.
This handy cut-off switch lets you quickly and easily disconnect your battery for safety when... see moreThis handy cut-off switch lets you quickly and easily disconnect your battery for safety when servicing your vehicle or in storage, to eliminate battery drain while vehicle is not in use, and for security as an anti-theft device. Install on the negative post of your battery, attach battery cable to the switch and you're done! To engage power close the lever (made of quality solid copper). To disconnect power open the lever.