Also fits*:* This fit is only a guideline. Please verify the fit by entering your specific vehicle.
Make
Model
Years
CHEVROLET
FULLSIZE 1955-57
1957
CONNECTS TO: - Dash Harness Temperature Sending Unit Connection - Ignition Coil ("+" terminal) - Ignition Switch - Oil Pressure Sending Unit - Oil Pressure Warning Light - Starter Motor Solenoid - Temperature Sending Unit
blower motor resistor to thermostat switch, with 1st design thermostat switch (wires attach to switch,... see moreblower motor resistor to thermostat switch, with 1st design thermostat switch (wires attach to switch, outside of the switch cover), without compressor relay
1" black high temperature, adhesive, 100 ft. roll, Note: This is high temperature tape, commonly... see more1" black high temperature, adhesive, 100 ft. roll, Note: This is high temperature tape, commonly used on Transistor Ignition Harnesses or on parts of harnesses which route in areas exposed to high temperatures, near exhaust manifolds, over intake manifolds, etc.
with push button radio that has external power supply (wire from power pack to speaker)... see morewith push button radio that has external power supply (wire from power pack to speaker) Use when installing original, replacement, or aftermarket speaker. Made with correct connector for hook-up to current GM replacement speaker and correct connector for connection to original radio or rear speaker fader switch wiring. You can cut off connector for hook-up to current GM replacement speaker and solder wires directly to original speaker (as was done originally) or aftermarket speaker