all with 36 gallon tank (from Rear Body Harness connector to fuel tank sending unit)
Additional information
Lectric Limited Part #
VFS6500
OEM Part #
92963781
WebID Part #
id-vfs6500-0001
Weight
0.2 lbs
You have not selected a vehicle
Also fits*:* This fit is only a guideline. Please verify the fit by entering your specific vehicle.
Make
Model
Years
CHEVROLET
CORVETTE
1965
CONNECTS TO:
– Fuel Tank Sending Unit (power feed, return signal & ground)
– Ground (driver side courtesy light bracket mounting screw)
– Rear Body Harness Connector
all big block coupe with backup lights. Includes VMA6500WB, VIG6500BB, VHL6465M, VHX6367, VRH6500CWB, & VTR6465AX.... see moreall big block coupe with backup lights. Includes VMA6500WB, VIG6500BB, VHL6465M, VHX6367, VRH6500CWB, & VTR6465AX. Retail price reflects a 10% savings! Options: --No Additional Option
--ORIGINAL DESIGN SERIES WIRING HARNESS SET OPTION: all small block with AFTERMARKET air conditioning
--ORIGINAL DESIGN SERIES WIRING HARNESS SET OPTION: all small block with factory air conditioning
--ORIGINAL DESIGN SERIES WIRING HARNESS SET OPTION: all small block without air conditioning. For use with alternator / voltage regulator / and horn relay re-located from original passenger side location to driver side
--ORIGINAL DESIGN SERIES WIRING HARNESS SET OPTION: all big block with point ignition in place of factory transistor ignition
This handy cut-off switch lets you quickly and easily disconnect your battery for safety when... see moreThis handy cut-off switch lets you quickly and easily disconnect your battery for safety when servicing your vehicle or in storage, to eliminate battery drain while vehicle is not in use, and for security as an anti-theft device. Install on the negative post of your battery, attach battery cable to the switch and you're done! To engage power close the lever (made of quality solid copper). To disconnect power open the lever.
blade width .04". If you need to remove a metal terminal from its plastic connector,... see moreblade width .04". If you need to remove a metal terminal from its plastic connector, this genuine Aptive/Delphi tool allows you to depress & release the locking tang on most terminals used by GM from 1950-80s. Not for use with Weather-Pak terminals. Made in USA.