Also fits*:* This fit is only a guideline. Please verify the fit by entering your specific vehicle.
Make
Model
Years
BUICK
SKYLARK/SPECIAL/GRAN SPORT
1967 - 1970
BUICK
FULLSIZE/RIVIERA
1967 - 1970
CADILLAC
FLEETWOOD/SEVILLE/DEVILLE/EL DORADO
1968 - 1970
CHEVROLET
CAMARO
1967
CHEVROLET
CHEVELLE/EL CAMINO/MONTE CARLO/MALIBU
1967
CHEVROLET
CORVETTE
1967
OLDSMOBILE
CUTLASS/442/F-85
1961 - 1967
OLDSMOBILE
FULLSIZE
1960 - 1967
PONTIAC
FIREBIRD/TRANS AM
1967
TECH NOTES:
A relay is an electrically operated switch that opens and closes under the control of another switch or electrical circuit.
Relays are used where it is necessary to control a high-power circuit with a low-power signal (with complete electrical isolation between control and controlled circuits), or where several circuits must be controlled by one signal.
Common uses for relays in older vehicles include controlling power windows, power seats, power top, horns, and rear window defroster.
front single dash speaker, Use when installing original, replacement, or aftermarket speaker. Made with correct... see morefront single dash speaker, Use when installing original, replacement, or aftermarket speaker. Made with correct connector for hook-up to current GM replacement speaker and correct connector for connection to original radio or radio harness. You can cut off connector for hook-up to current GM replacement speaker and solder wires directly to original speaker (as was done originally) or aftermarket speaker.
Conveniently charge/maintain your vehicle's battery through the cigarette lighter or power plug port. Fuse protected... see moreConveniently charge/maintain your vehicle's battery through the cigarette lighter or power plug port. Fuse protected with 12" cord. Connects to Battery Butler Storage Charger (BBFC100 & BBFC200). Note: Adapter should only be used in a cigarette lighter or power plug port that is NOT energized by the ignition switch.
GM H.E.I. (High Energy Ignition) style distributor. Order the correct harness part # for your... see moreGM H.E.I. (High Energy Ignition) style distributor. Order the correct harness part # for your car along with this modification part #. The harness you need to order is usually the Engine Harness, but can be the Dash Harness. To verify, check the wiring going to the ignition coil and ballast resistor (if applicable) in your car.