-reproduction-, V8 (mounts to coil bracket, connects to positive post on coil)
Additional information
Lectric Limited Part #
01852715
OEM Part #
01852715
WebID Part #
id-01852715-0002
Weight
0.1 lbs
You have not selected a vehicle
Also fits*:* This fit is only a guideline. Please verify the fit by entering your specific vehicle.
Make
Model
Years
CHEVROLET
CAMARO
1971 - 1974
CHEVROLET
CHEVELLE/EL CAMINO/MONTE CARLO/MALIBU
1971 - 1974
CHEVROLET
CHEVY II/NOVA
1971 - 1974
CHEVROLET
CORVETTE
1972 - 1974
CHEVROLET
FULLSIZE 1958 & UP
1971 - 1974
CHEVROLET
TRUCK/PICK-UP/SUBURBAN/BLAZER
1972 - 1974
TECH NOTES:
Ignition systems, charging systems, electrical devices, and switches can create magnetic pulses. These pulses are in the same frequency range as AM-band radio signals resulting in radio "noise".
This radio noise suppression capacitor diverts this noise to ground so it isn't heard through the radio's speakers as an annoying buzz or whine.
There can be several radio capacitors in a vehicle.
As with any electrolytic capacitor, radio capacitors have a limited life and will degrade over time as the internal electrolyte evaporates; especially in areas of temperature extremes (hot or cold).
adapts "T" shaped motor connector to side by side blade type motor connectoradapts "T" shaped motor connector to side by side blade type motor connector
1" black high temperature, adhesive, 100 ft. roll, Note: This is high temperature tape, commonly... see more1" black high temperature, adhesive, 100 ft. roll, Note: This is high temperature tape, commonly used on Transistor Ignition Harnesses or on parts of harnesses which route in areas exposed to high temperatures, near exhaust manifolds, over intake manifolds, etc.
Keeps your battery fully charged and maintained to extend battery life. Monitoring circuitry automatically turns... see moreKeeps your battery fully charged and maintained to extend battery life. Monitoring circuitry automatically turns charger on & off as needed. Fully protected against overcharging, short circuits, and reverse polarity. Features red/green LED indicator light status. Includes both clamp and fused ring-terminal connection adapters. Works on all 6 or 12 volt lead-acid Wet/AGM/Gel batteries. Plug charger it into any 110 volt socket, connect to your battery, and forget about it!