-reproduction-, 2nd Series, 12 volt (mounts to coil bracket, connects to positive post on coil)
Additional information
Lectric Limited Part #
01929070
OEM Part #
01929070
WebID Part #
id-01929070-0005
Weight
0.1 lbs
You have not selected a vehicle
Also fits*:* This fit is only a guideline. Please verify the fit by entering your specific vehicle.
Make
Model
Years
CADILLAC
FLEETWOOD/SEVILLE/DEVILLE/EL DORADO
1956 - 1961
CHEVROLET
TRUCK/PICK-UP/SUBURBAN/BLAZER
1955 - 1959
CHEVROLET
CORVETTE
1956 - 1959
CHEVROLET
FULLSIZE 1955-57
1955 - 1957
CHEVROLET
FULLSIZE 1958 & UP
1958 - 1959
OLDSMOBILE
FULLSIZE
1956
TECH NOTES:
Ignition systems, charging systems, electrical devices, and switches can create magnetic pulses. These pulses are in the same frequency range as AM-band radio signals, resulting in radio "noise".
This radio noise suppression capacitor diverts this noise to ground so it isn't heard through the radio's speakers as an annoying buzz or whine.
There can be several radio capacitors in a vehicle.
As with any electrolytic capacitor, radio capacitors have a limited life and will degrade over time as the internal electrolyte evaporates; especially in areas of temperature extremes (hot or cold).
This handy cut-off switch lets you quickly and easily disconnect your battery for safety when... see moreThis handy cut-off switch lets you quickly and easily disconnect your battery for safety when servicing your vehicle or in storage, to eliminate battery drain while vehicle is not in use, and for security as an anti-theft device. Install on the negative post of your battery, attach battery cable to the switch and you're done! To engage power just hand tighten the green knob. To disconnect power, slightly loosen the knob or, on this top-post model, completely remove the knob to discourage unauthorized use while stored at home, parked, or when traveling.
blade width .04". If you need to remove a metal terminal from its plastic connector,... see moreblade width .04". If you need to remove a metal terminal from its plastic connector, this genuine Aptive/Delphi tool allows you to depress & release the locking tang on most terminals used by GM from 1950-80s. Not for use with Weather-Pak terminals. Made in USA.
-reproduction-, 2nd Series, 12 Volt (mounts to voltage regulator, connects to bat terminal on regulator)-reproduction-, 2nd Series, 12 Volt (mounts to voltage regulator, connects to bat terminal on regulator)