-reproduction-, cars built after January 10, 1971 (mounts to voltage regulator, connects to ground tab on regulator)
Additional information
Lectric Limited Part #
01960957
OEM Part #
01960957
WebID Part #
id-01960957-0010
Weight
0.1 lbs
You have not selected a vehicle
Also fits*:* This fit is only a guideline. Please verify the fit by entering your specific vehicle.
Make
Model
Years
CADILLAC
FLEETWOOD/SEVILLE/DEVILLE/EL DORADO
1963 - 1972
CHEVROLET
CAMARO
1971 - 1972
CHEVROLET
CHEVELLE/EL CAMINO/MONTE CARLO/MALIBU
1971 - 1972
CHEVROLET
CHEVY II/NOVA
1963 - 1972
CHEVROLET
CORVETTE
1963 - 1965
CHEVROLET
FULLSIZE 1958 & UP
1963 - 1972
CHEVROLET
TRUCK/PICK-UP/SUBURBAN/BLAZER
1972
OLDSMOBILE
FULLSIZE
1962 - 1972
OLDSMOBILE
TORONADO
1966 - 1971
PONTIAC
FIREBIRD/TRANS AM
1967 - 1968
PONTIAC
FULLSIZE/GRAND PRIX
1962 - 1968
TECH NOTES:
Ignition systems, charging systems, electrical devices, and switches can create magnetic pulses. These pulses are in the same frequency range as AM-band radio signals, resulting in radio "noise".
This radio noise suppression capacitor diverts this noise to ground so it isn't heard through the radio's speakers as an annoying buzz or whine.
There can be several radio capacitors in a vehicle.
As with any electrolytic capacitor, radio capacitors have a limited life and will degrade over time as the internal electrolyte evaporates; especially in areas of temperature extremes (hot or cold).
This item is packaged with (2) similar connectors of different colors. The customer must determine which connector to use.
This handy cut-off switch lets you quickly and easily disconnect your battery for safety when... see moreThis handy cut-off switch lets you quickly and easily disconnect your battery for safety when servicing your vehicle or in storage, to eliminate battery drain while vehicle is not in use, and for security as an anti-theft device. Install on the negative post of your battery, attach battery cable to the switch and you're done! To engage power just hand tighten the green knob. To disconnect power, slightly loosen the knob or, on this top-post model, completely remove the knob to discourage unauthorized use while stored at home, parked, or when traveling.
(wiring from speaker to speaker harness connector, 1 required per speaker) Use when installing aftermarket... see more(wiring from speaker to speaker harness connector, 1 required per speaker) Use when installing aftermarket speakers. Made to solder wires directly to aftermarket speaker and with correct connector for connection to original wiring.
Conveniently charge/maintain your vehicle's battery through the cigarette lighter or power plug port. Fuse protected... see moreConveniently charge/maintain your vehicle's battery through the cigarette lighter or power plug port. Fuse protected with 12" cord. Connects to Battery Butler Storage Charger (BBFC100 & BBFC200). Note: Adapter should only be used in a cigarette lighter or power plug port that is NOT energized by the ignition switch.
Keeps your battery fully charged and maintained to extend battery life. Monitoring circuitry automatically turns... see moreKeeps your battery fully charged and maintained to extend battery life. Monitoring circuitry automatically turns charger on & off as needed. Fully protected against overcharging, short circuits, and reverse polarity. Features red/green LED indicator light status. Includes both clamp and fused ring-terminal connection adapters. Works on all 6 or 12 volt lead-acid Wet/AGM/Gel batteries. Plug charger it into any 110 volt socket, connect to your battery, and forget about it!