jumper to passenger side rear tail light and tailgate, Parkwood 4 Door Wagon, without backup lights Note: This harness completes rear body panel wiring to inside the tailgate and passenger side rear tail light ****NOTE: CUSTOMER MUST SUPPLY AN ORIGINAL HARNESS FOR USE OF VARIOUS CONNECTORS AND TAILGATE BOOT**** NOTE: This part shown for reference only. It is NOT available.
rear single speaker, Note: This harness is used with a RADIO HARNESS to complete rear... see morerear single speaker, Note: This harness is used with a RADIO HARNESS to complete rear speaker wiring
This handy cut-off switch lets you quickly and easily disconnect your battery for safety when... see moreThis handy cut-off switch lets you quickly and easily disconnect your battery for safety when servicing your vehicle or in storage, to eliminate battery drain while vehicle is not in use, and for security as an anti-theft device. Install on the negative post of your battery, attach battery cable to the switch and you're done! To engage power just hand tighten the green knob. To disconnect power, slightly loosen the knob or, on this top-post model, completely remove the knob to discourage unauthorized use while stored at home, parked, or when traveling.
blade width .08". If you need to remove a metal terminal from its plastic connector,... see moreblade width .08". If you need to remove a metal terminal from its plastic connector, this genuine Aptive/Delphi tool allows you to depress & release the locking tang on most terminals used by GM from 1950-80s. Not for use with Weather-Pak terminals. Made in USA.