-O.E.M. made using original GM tooling-, except Pick-Up
Additional information
Lectric Limited Part #
15667712
OEM Part #
15667712
WebID Part #
id-15667712-0002
Weight
0.2 lbs
You have not selected a vehicle
Also fits*:* This fit is only a guideline. Please verify the fit by entering your specific vehicle.
Make
Model
Years
CHEVROLET
TRUCK/PICK-UP/SUBURBAN/BLAZER
1992 - 1993
GMC
TRUCK
1992 - 1993
TECH NOTES:
A relay is an electrically operated switch that opens and closes under the control of another switch or electrical circuit.
Relays are used where it is necessary to control a high-power circuit with a low-power signal (with complete electrical isolation between control and controlled circuits), or where several circuits must be controlled by one signal.
In the case of a rear window defroster relay/timer, the defroster is activated or deactivated through this relay when the rear window defroster switch is pressed. It will also automatically deactivate when the relay's programmed timing cycle ends or the ignition switch is turned to the off position.
This handy cut-off switch lets you quickly and easily disconnect your battery for safety when... see moreThis handy cut-off switch lets you quickly and easily disconnect your battery for safety when servicing your vehicle or in storage, to eliminate battery drain while vehicle is not in use, and for security as an anti-theft device. Install on the negative post of your battery, attach battery cable to the switch and you're done! To engage power just hand tighten the green knob. To disconnect power, slightly loosen the knob or, on this top-post model, completely remove the knob to discourage unauthorized use while stored at home, parked, or when traveling.
This handy cut-off switch lets you quickly and easily disconnect your battery for safety when... see moreThis handy cut-off switch lets you quickly and easily disconnect your battery for safety when servicing your vehicle or in storage, to eliminate battery drain while vehicle is not in use, and for security as an anti-theft device. Install on the negative post of your battery, attach battery cable to the switch and you're done! To engage power close the lever (made of quality solid copper). To disconnect power open the lever.