speaker lead wires to front single roof speaker, 2nd Series, 12 volt Use when installing replacement, or aftermarket speaker. Made with correct connectors to connect to original speaker wiring and solder wires directly to replacement or aftermarket speaker
Additional information
Lectric Limited Part #
90622
WebID Part #
id-90622-0001
Weight
0.1 lbs
You have not selected a vehicle
Also fits*:* This fit is only a guideline. Please verify the fit by entering your specific vehicle.
2nd Series, 12 volt, with Cool Pack A/C floor unit use when replacing an original... see more2nd Series, 12 volt, with Cool Pack A/C floor unit use when replacing an original 5 cylinder compressor with a compressor that has 2 blade type terminals on compressor clutch
fuse panel to blower motor switch, 2nd Series, 12 volt, with Standard Re-Circulating Heater, without... see morefuse panel to blower motor switch, 2nd Series, 12 volt, with Standard Re-Circulating Heater, without Cool Pack A/C under dash unit
1" black high temperature, adhesive, 100 ft. roll, Note: This is high temperature tape, commonly... see more1" black high temperature, adhesive, 100 ft. roll, Note: This is high temperature tape, commonly used on Transistor Ignition Harnesses or on parts of harnesses which route in areas exposed to high temperatures, near exhaust manifolds, over intake manifolds, etc.
1st Series, 6 volt or converting to 12 volt, 6 Cyl. Note: This harness set... see more1st Series, 6 volt or converting to 12 volt, 6 Cyl. Note: This harness set is built upgraded for turn signals, 2 rear taillights, and includes installation diagrams. PLUS, provisions and diagrams for the ignition system if changing to a 12 volt electrical system. Harnesses route and install as original.