-original 1/2 x 14 N.P.T.F.-, without A/C Note: Requires a double 56 series female terminal connection
Additional information
Lectric Limited Part #
01993561
OEM Part #
01998181
WebID Part #
id-01993561-0019
Weight
0.2 lbs
You have not selected a vehicle
Also fits*:* This fit is only a guideline. Please verify the fit by entering your specific vehicle.
Make
Model
Years
BUICK
FULLSIZE/RIVIERA
1960 - 1968
BUICK
SKYLARK/SPECIAL/GRAN SPORT
1965 - 1968
CHEVROLET
FULLSIZE 1958 & UP
1962 - 1966
CHEVROLET
TRUCK/PICK-UP/SUBURBAN/BLAZER
1962 - 1966
OLDSMOBILE
FULLSIZE
1956 - 1969
PONTIAC
FULLSIZE/GRAND PRIX
1959 - 1964
TECH NOTES:
This Temperature Sending Unit (Switch) actuates a warning light (idiot light) when the engine exceeds a specific temperature.
NOTE: Vehicles with gauges (not warning lights) should not use this sending unit. Vehicles with gauges require a different type of sending unit that varies resistance with engine temperature.
Unless necessary to prevent leaking, we recommend that you do NOT use Teflon (TM) tape, pipe compound, or any other sealant when installing this sending unit. Simply screw it in. Adding anything onto the sending unit's threads may result in improper operation.
This handy cut-off switch lets you quickly and easily disconnect your battery for safety when... see moreThis handy cut-off switch lets you quickly and easily disconnect your battery for safety when servicing your vehicle or in storage, to eliminate battery drain while vehicle is not in use, and for security as an anti-theft device. Install on the negative post of your battery, attach battery cable to the switch and you're done! To engage power just hand tighten the green knob. To disconnect power, slightly loosen the knob or, on this top-post model, completely remove the knob to discourage unauthorized use while stored at home, parked, or when traveling.
GM H.E.I. (High Energy Ignition) style distributor. Order the correct harness part # for your... see moreGM H.E.I. (High Energy Ignition) style distributor. Order the correct harness part # for your car along with this modification part #. The harness you need to order is usually the Engine Harness, but can be the Dash Harness. To verify, check the wiring going to the ignition coil and ballast resistor (if applicable) in your car.
for use in stock generator/alternator original mounting location. Order correct harness part # for your... see morefor use in stock generator/alternator original mounting location. Order correct harness part # for your car along with this modification part #.