FREE CRIMPER SET ($119 value) with purchase of RestoMod or Classic Update Wiring System. 
Description
with factory gauges (includes new asphalt loom, wire, terminal, & connector)
“DASH HARNESS” has been added to your cart. View cart
TEMPERATURE SENDING UNIT LEAD REPAIR KIT
Part #: VRK6871TS
$24.00
You have not selected a vehicle
Additional information
- Lectric Limited Part #
- VRK6871TS
- WebID Part #
- id-vrk6871ts-0005
- Weight
- 0.1 lbs
You have not selected a vehicle
Also fits*:* This fit is only a guideline. Please verify the fit by entering your specific vehicle.
| Make | Model | Years |
|---|---|---|
| CHEVROLET | CAMARO | 1968 |
| CHEVROLET | CHEVELLE/EL CAMINO/MONTE CARLO/MALIBU | 1968 |
| CHEVROLET | CHEVY II/NOVA | 1968 |
| CHEVROLET | CORVETTE | 1968 - 1971 |
| CHEVROLET | FULLSIZE 1958 & UP | 1968 |
TECH NOTES:
Over the years, the terminal, connector, and wire to the temperature sending unit may have been altered by a previous owner or mechanic. This was not uncommon. This alteration was most likely made in order to try different sending units when the "exact replacement" unit didn't work or was not available. After finding a sending unit that "worked", they would cut-off the original terminal & connector from their harness and splice-on the one that mated to their new sending unit.
With Lectric Limited's Temperature Sending Unit Lead Repair Kit you can repair or replace your temperature sending unit lead wire and get your wiring harness back to the way it originally looked and functioned.
This easy-to-install kit comes with pre-terminated wire, plastic connector, and tar-coated loom (sleeve) ready for you to splice into your existing wiring harness. Heat shrink and harness tape are not included but may be required. Non-adhesive vinyl harness tape available separately. (See "Repair Components" section)
Over the years, the terminal, connector, and wire to the temperature sending unit may have been altered by a previous owner or mechanic. This was not uncommon. This alteration was most likely made in order to try different sending units when the "exact replacement" unit didn't work or was not available. After finding a sending unit that "worked", they would cut-off the original terminal & connector from their harness and splice-on the one that mated to their new sending unit.
With Lectric Limited's Temperature Sending Unit Lead Repair Kit you can repair or replace your temperature sending unit lead wire and get your wiring harness back to the way it originally looked and functioned.
This easy-to-install kit comes with pre-terminated wire, plastic connector, and tar-coated loom (sleeve) ready for you to splice into your existing wiring harness. Heat shrink and harness tape are not included but may be required. Non-adhesive vinyl harness tape available separately. (See "Repair Components" section)
Frequently Bought Together
-
FRONT LIGHT HARNESS
6 Cyl., with warning lights & fender lights
FLASHER: HAZARD
-replacement made in Taiwan-, Replaces 12 volt flasher #'s 146, 170, 175, 552, and SF552.... see more
SPEAKER LEAD WIRES
front single dash speaker, Use when installing original, replacement, or aftermarket speaker. Made with correct... see more
TURN SIGNAL SWITCH
-O.E.M. made in U.S.A. using original GM/Delco tooling-, "BOYNE" type (includes wiring) Note: On 1967... see more
