all 2nd design: pigtail on amplifier box (from internal circuit board to Transistor Ignition Auxiliary Harness connector)
Additional information
Lectric Limited Part #
VTR6871BXT
OEM Part #
00800127
WebID Part #
id-vtr6871bxt-0003
Weight
0.2 lbs
You have not selected a vehicle
Also fits*:* This fit is only a guideline. Please verify the fit by entering your specific vehicle.
Make
Model
Years
CHEVROLET
CAMARO
1969 - 1973
CHEVROLET
CORVETTE
1968 - 1971
TECH NOTES:
The Transistor Ignition (T.I.) Amplifier Box Extension is the short wiring that goes from the internal circuit board (inside the T.I. box) that includes the rubber molded T.I. Amplifier box housing connector -to- the T.I. Auxiliary Harness's molded rubber connector. Basically, it is the wiring exiting the amplifier box.
This extension appears to be is the weakest link in the entire T.I. system and must be replaced if you have not already done so. Over the years, the spring-tension on the female terminals of this wiring will lose their grip on the male terminals they connect to, causing your engine to quit!
CONNECTS TO: - Harness Connections (on the circuit board Inside an original T.I. box) - Transistor Ignition Auxiliary Harness Connection
for use only with our RestoMod Series wiring system, should your Mega-Fuse become damaged or... see morefor use only with our RestoMod Series wiring system, should your Mega-Fuse become damaged or in need of replacement. NOTE: 2 of these Mega-Fuses are already included with our RestoMod Series wiring system.
This handy cut-off switch lets you quickly and easily disconnect your battery for safety when... see moreThis handy cut-off switch lets you quickly and easily disconnect your battery for safety when servicing your vehicle or in storage, to eliminate battery drain while vehicle is not in use, and for security as an anti-theft device. Install on the negative post of your battery, attach battery cable to the switch and you're done! To engage power just hand tighten the green knob. To disconnect power, slightly loosen the knob or, on this top-post model, completely remove the knob to discourage unauthorized use while stored at home, parked, or when traveling.
fuse block to windshield wiper switch bezel, This wire allows you to add a light... see morefuse block to windshield wiper switch bezel, This wire allows you to add a light to your windshield wiper switch, as used on 1973-76, without cutting or splicing any wiring. Intended for use with, but does not include, a 1973-76 windshield wiper switch bezel. (Includes light bulb)