internal circuit board to amplifier housing connector,
Additional information
Lectric Limited Part #
VTR6468BXT
OEM Part #
02986672
WebID Part #
id-vtr6468bxt-0002
Weight
0.1 lbs
You have not selected a vehicle
Also fits*:* This fit is only a guideline. Please verify the fit by entering your specific vehicle.
Make
Model
Years
CHEVROLET
CAMARO
1967 - 1969
CHEVROLET
CHEVELLE/EL CAMINO/MONTE CARLO/MALIBU
1964 - 1966
CHEVROLET
CHEVY II/NOVA
1966
CHEVROLET
CORVETTE
1964 - 1968
CHEVROLET
FULLSIZE 1958 & UP
1964 - 1967
PONTIAC
FULLSIZE/GRAND PRIX
1964
PONTIAC
TEMPEST/LEMANS/GTO/T-37/GRAND AM/VENTURA
1964
TECH NOTES:
The Transistor Ignition (T.I.) Amplifier Box Extension is the short wiring that goes from the internal circuit board (inside the T.I. box) that includes the rubber molded T.I. Amplifier box housing connector -to- the T.I. Auxiliary Harness's molded rubber connector. Basically, it is the wiring exiting the amplifier box.
This extension appears to be is the weakest link in the entire T.I. system and must be replaced if you have not already done so. Over the years, the spring-tension on the female terminals of this wiring will lose their grip on the male terminals they connect to, causing your engine to quit!
ATO/ATC "standard" blade, Troubleshoot your electrical system, pinpoint electrical issues, and skip the hassle of... see moreATO/ATC "standard" blade, Troubleshoot your electrical system, pinpoint electrical issues, and skip the hassle of replacing blown fuses. Features a manual push-button reset allowing you to restore power quickly once the issue is found. This circuit breaker set includes 3, 5, 7.5, 10, 15, 20, 25, and 30 amp ratings.
front kick panel speaker, (wiring from speaker to speaker connector, 1 required per speaker) Use... see morefront kick panel speaker, (wiring from speaker to speaker connector, 1 required per speaker) Use when installing original, replacement, or aftermarket speakers. Made with correct connector for hook-up to current GM replacement speaker and correct connector for connection to original wiring, or cut off connector for hook-up to current GM replacement speaker and solder wires directly to original speaker (as was done originally) or aftermarket speaker.