internal circuit board to Transistor Ignition Auxiliary Harness distributor connector, Note: This harness will work with any Delco Transistor Ignition amplifier being rebuilt/restored using part #VTR6571AM TRANSISTOR IGNITION AMPLIFIER BOX MODULE
Additional information
Lectric Limited Part #
90271
WebID Part #
id-90271-0001
Weight
0.5 lbs
You have not selected a vehicle
Also fits*:* This fit is only a guideline. Please verify the fit by entering your specific vehicle.
Make
Model
Years
PONTIAC
FULLSIZE/GRAND PRIX
1963
PONTIAC
TEMPEST/LEMANS/GTO/T-37/GRAND AM/VENTURA
1963
TECH NOTES:
The Transistor Ignition (T.I.) Amplifier Box Extension is the short wiring that goes from the internal circuit board (inside the T.I. box) that includes the rubber molded T.I. Amplifier box housing connector -to- the T.I. Auxiliary Harness's molded rubber connector. Basically, it is the wiring exiting the amplifier box.
This extension appears to be is the weakest link in the entire T.I. system and must be replaced if you have not already done so. Over the years, the spring-tension on the female terminals of this wiring will lose their grip on the male terminals they connect to, causing your engine to quit!
V8 all 1st design: short spark plug bracket mounted to passenger side intake manifold, except... see moreV8 all 1st design: short spark plug bracket mounted to passenger side intake manifold, except 421 C.I. Super Duty (Dated 3-Q-62)
ignition switch to coil & ballast resistor, 421 C.I. Super Duty, without transistor ignitionignition switch to coil & ballast resistor, 421 C.I. Super Duty, without transistor ignition
1" black high temperature, adhesive, 100 ft. roll, Note: This is high temperature tape, commonly... see more1" black high temperature, adhesive, 100 ft. roll, Note: This is high temperature tape, commonly used on Transistor Ignition Harnesses or on parts of harnesses which route in areas exposed to high temperatures, near exhaust manifolds, over intake manifolds, etc.