internal circuit board to amplifier housing connector,
Additional information
Lectric Limited Part #
VTR6468BXT
OEM Part #
02986672
WebID Part #
id-vtr6468bxt-0006
Weight
0.1 lbs
You have not selected a vehicle
Also fits*:* This fit is only a guideline. Please verify the fit by entering your specific vehicle.
Make
Model
Years
CHEVROLET
CAMARO
1967 - 1969
CHEVROLET
CHEVELLE/EL CAMINO/MONTE CARLO/MALIBU
1964 - 1966
CHEVROLET
CHEVY II/NOVA
1966
CHEVROLET
CORVETTE
1964 - 1968
CHEVROLET
FULLSIZE 1958 & UP
1964 - 1967
PONTIAC
FULLSIZE/GRAND PRIX
1964
PONTIAC
TEMPEST/LEMANS/GTO/T-37/GRAND AM/VENTURA
1964
TECH NOTES:
The Transistor Ignition (T.I.) Amplifier Box Extension is the short wiring that goes from the internal circuit board (inside the T.I. box) that includes the rubber molded T.I. Amplifier box housing connector -to- the T.I. Auxiliary Harness's molded rubber connector. Basically, it is the wiring exiting the amplifier box.
This extension appears to be is the weakest link in the entire T.I. system and must be replaced if you have not already done so. Over the years, the spring-tension on the female terminals of this wiring will lose their grip on the male terminals they connect to, causing your engine to quit!
console courtesy light, automatic trans., early production: console harness, rear section, has the console light... see moreconsole courtesy light, automatic trans., early production: console harness, rear section, has the console light socket, a connection for the ground wire to the console courtesy light, & connection for the courtesy light slide switch at rear of console
This handy cut-off switch lets you quickly and easily disconnect your battery for safety when... see moreThis handy cut-off switch lets you quickly and easily disconnect your battery for safety when servicing your vehicle or in storage, to eliminate battery drain while vehicle is not in use, and for security as an anti-theft device. Install on the negative post of your battery, attach battery cable to the switch and you're done! To engage power close the lever (made of quality solid copper). To disconnect power open the lever.
-original 1/2 x 14 N.P.T.F.-, with factory gauges/Rally Gauges (correct resistance and connection, produces accurate... see more-original 1/2 x 14 N.P.T.F.-, with factory gauges/Rally Gauges (correct resistance and connection, produces accurate gauge display)