internal circuit board to Transistor Ignition Auxiliary Harness distributor connector, Note: This harness will only work with an original 1963 amplifier part #1115002, that has an original 4 pin terminal circuit board intact and functioning
Additional information
Lectric Limited Part #
90270
OEM Part #
02982411
WebID Part #
id-90270-0002
Weight
0.6 lbs
You have not selected a vehicle
Also fits*:* This fit is only a guideline. Please verify the fit by entering your specific vehicle.
Make
Model
Years
PONTIAC
FULLSIZE/GRAND PRIX
1963
PONTIAC
TEMPEST/LEMANS/GTO/T-37/GRAND AM/VENTURA
1963
TECH NOTES:
The Transistor Ignition (T.I.) Amplifier Box Extension is the short wiring that goes from the internal circuit board (inside the T.I. box) that includes the rubber molded T.I. Amplifier box housing connector -to- the T.I. Auxiliary Harness's molded rubber connector. Basically, it is the wiring exiting the amplifier box.
This extension appears to be is the weakest link in the entire T.I. system and must be replaced if you have not already done so. Over the years, the spring-tension on the female terminals of this wiring will lose their grip on the male terminals they connect to, causing your engine to quit!
3/4" black cotton cloth, adhesive, 60 ft. roll, Note: This is not high temperature tape3/4" black cotton cloth, adhesive, 60 ft. roll, Note: This is not high temperature tape
This handy cut-off switch lets you quickly and easily disconnect your battery for safety when... see moreThis handy cut-off switch lets you quickly and easily disconnect your battery for safety when servicing your vehicle or in storage, to eliminate battery drain while vehicle is not in use, and for security as an anti-theft device. Install on the negative post of your battery, attach battery cable to the switch and you're done! To engage power just hand tighten the green knob. To disconnect power, slightly loosen the knob or, on this top-post model, completely remove the knob to discourage unauthorized use while stored at home, parked, or when traveling.
20-14 gauge terminal crimper, not intended for use with Weather-Pak or Metri-Pac terminals requiring rubber... see more20-14 gauge terminal crimper, not intended for use with Weather-Pak or Metri-Pac terminals requiring rubber seals