all (from internal circuit board to amplifier housing connector)
Additional information
Lectric Limited Part #
VTR6468BXT
OEM Part #
02986672
WebID Part #
id-vtr6468bxt-0003
Weight
0.1 lbs
You have not selected a vehicle
Also fits*:* This fit is only a guideline. Please verify the fit by entering your specific vehicle.
Make
Model
Years
CHEVROLET
CAMARO
1967 - 1969
CHEVROLET
CHEVELLE/EL CAMINO/MONTE CARLO/MALIBU
1964 - 1966
CHEVROLET
CHEVY II/NOVA
1966
CHEVROLET
CORVETTE
1964 - 1968
CHEVROLET
FULLSIZE 1958 & UP
1964 - 1967
PONTIAC
FULLSIZE/GRAND PRIX
1964
PONTIAC
TEMPEST/LEMANS/GTO/T-37/GRAND AM/VENTURA
1964
TECH NOTES:
The Transistor Ignition (T.I.) Amplifier Box Extension is the short wiring that goes from the internal circuit board (inside the T.I. box) that includes the rubber molded T.I. Amplifier box housing connector -to- the T.I. Auxiliary Harness's molded rubber connector. Basically, it is the wiring exiting the amplifier box.
This extension appears to be is the weakest link in the entire T.I. system and must be replaced if you have not already done so. Over the years, the spring-tension on the female terminals of this wiring will lose their grip on the male terminals they connect to, causing your engine to quit!
all small block coupe with backup lights without air conditioning. Includes VMA6500WB, VIG6465, VHL6465M, VHX6367,... see moreall small block coupe with backup lights without air conditioning. Includes VMA6500WB, VIG6465, VHL6465M, VHX6367, & VRH6500CWB. Retail price reflects a 10% savings! Options: --No Additional Option
--ORIGINAL DESIGN SERIES WIRING HARNESS SET OPTION: all small block with AFTERMARKET air conditioning
--ORIGINAL DESIGN SERIES WIRING HARNESS SET OPTION: all small block with factory air conditioning
--ORIGINAL DESIGN SERIES WIRING HARNESS SET OPTION: all small block without air conditioning. For use with alternator / voltage regulator / and horn relay re-located from original passenger side location to driver side
--ORIGINAL DESIGN SERIES WIRING HARNESS SET OPTION: all big block with point ignition in place of factory transistor ignition
all (includes all terminals, connectors, & instructions as used by factory to convert Engine Harness... see moreall (includes all terminals, connectors, & instructions as used by factory to convert Engine Harness and Dash Harness to accept transistor ignition. Included with our Transistor Ignition Auxiliary Harness.)
Dash Harness to power antenna switch connection, fused jumper harness allows you to add 15... see moreDash Harness to power antenna switch connection, fused jumper harness allows you to add 15 amp fuse protection into this non-fused battery powered circuit.