located on passenger side cylinder head, -O.E.M. replacement made in U.S.A.-, V8, big block
Additional information
Lectric Limited Part #
06489785
OEM Part #
06489785
WebID Part #
id-06489785-0005
Weight
0.1 lbs
You have not selected a vehicle
Also fits*:* This fit is only a guideline. Please verify the fit by entering your specific vehicle.
Make
Model
Years
CHEVROLET
FULLSIZE 1958 & UP
1970
CHEVROLET
CORVETTE
1970 - 1974
CHEVROLET
CAMARO
1970 - 1971
CHEVROLET
CHEVELLE/EL CAMINO/MONTE CARLO/MALIBU
1970
CHEVROLET
CHEVY II/NOVA
1970
TECH NOTES:
Introduced in 1970, the Transmission Controlled Spark (T.C.S.) System controls exhaust emissions by eliminating vacuum advance in the lower forward gears, while at operating temperature.
This Transmission Controlled Spark (T.C.S.) Switch is one component of the emission system. It screws into the cylinder head to detect coolant temperature. When activated, this switch is designed to override this system, until the engine temperature reaches a set temperature. This allows vacuum advance in all gears, thereby preventing stalling after starting.
After simple installation of this kit your courtesy lamps will remain on for a user... see moreAfter simple installation of this kit your courtesy lamps will remain on for a user adjustable amount of time (0-60 seconds), or until the ignition switch is turned to on or accessory. At the end of the delay function, the courtesy lights will gradually fade to dark.
This handy cut-off switch lets you quickly and easily disconnect your battery for safety when... see moreThis handy cut-off switch lets you quickly and easily disconnect your battery for safety when servicing your vehicle or in storage, to eliminate battery drain while vehicle is not in use, and for security as an anti-theft device. Install on the negative post of your battery, attach battery cable to the switch and you're done! To engage power just hand tighten the green knob. To disconnect power, slightly loosen the knob or, on this top-post model, completely remove the knob to discourage unauthorized use while stored at home, parked, or when traveling.
blade width .08". If you need to remove a metal terminal from its plastic connector,... see moreblade width .08". If you need to remove a metal terminal from its plastic connector, this genuine Aptive/Delphi tool allows you to depress & release the locking tang on most terminals used by GM from 1950-80s. Not for use with Weather-Pak terminals. Made in USA.