GM H.E.I. (High Energy Ignition) style distributor. Order the correct harness part # for your car along with this modification part #. The harness you need to order is usually the Engine Harness, but can be the Dash Harness. To verify, check the wiring going to the ignition coil and ballast resistor (if applicable) in your truck.
Additional information
Lectric Limited Part #
34590
OEM Part #
92963572
WebID Part #
id-34590-0018
Weight
0.1 lbs
You have not selected a vehicle
Also fits*:* This fit is only a guideline. Please verify the fit by entering your specific vehicle.
blade width .08". If you need to remove a metal terminal from its plastic connector,... see moreblade width .08". If you need to remove a metal terminal from its plastic connector, this genuine Aptive/Delphi tool allows you to depress & release the locking tang on most terminals used by GM from 1950-80s. Not for use with Weather-Pak terminals. Made in USA.
3/4" black cotton cloth, adhesive, 60 ft. roll, Note: This is not high temperature tape3/4" black cotton cloth, adhesive, 60 ft. roll, Note: This is not high temperature tape
front dual kick panel speakers, (wiring from speaker to speaker harness connector, 2 required per... see morefront dual kick panel speakers, (wiring from speaker to speaker harness connector, 2 required per car) Use when installing original, replacement, or aftermarket speakers. Made with correct connector for hook-up to current GM replacement speaker and correct connector for connection to original wiring, or cut off connector for hook-up to current GM replacement speaker and solder wires directly to original speaker (as was done originally) or aftermarket speaker. (wiring from speaker to speaker connector, 2 required per car)
Keeps your battery fully charged and maintained to extend battery life. Monitoring circuitry automatically turns... see moreKeeps your battery fully charged and maintained to extend battery life. Monitoring circuitry automatically turns charger on & off as needed. Fully protected against overcharging, short circuits, and reverse polarity. Features red/green LED indicator light status. Includes both clamp and fused ring-terminal connection adapters. Works on all 6 or 12 volt lead-acid Wet/AGM/Gel batteries. Plug charger it into any 110 volt socket, connect to your battery, and forget about it!