Also fits*:* This fit is only a guideline. Please verify the fit by entering your specific vehicle.
Make
Model
Years
CHEVROLET
CORVETTE
1969
TECH NOTES:
A wiring diagram is primarily used for troubleshooting electrical problems within a vehicle's electrical system. Our wiring diagrams show wire color, wire gauge, circuit number, wire position with in a connector, and graphics of to-and-from locations.
These diagrams are fully-laminated (both sides). So, while working on your vehicle, any grease/oil/dirt smudges can easily be wiped clean.
All Lectric Limited wiring diagrams graphically display all the wiring for a base model car (without factory options). Our diagrams are reproductions of those used by General Motors' mechanics, except they are displayed on one large page (not across multiple small pages).
Reprinted with permission from General Motors Corporation.
with cannister type coil This harness will allow you to easily replace your mechanical cable... see morewith cannister type coil This harness will allow you to easily replace your mechanical cable driven tachometer with a 1975-77 electric tachometer without cutting or splicing any wiring. Does not include tachometer or tachometer filter (which may be required for correct operation).
(wiring from speaker to speaker harness connector, 2 required per car) Use when installing original,... see more(wiring from speaker to speaker harness connector, 2 required per car) Use when installing original, replacement, or aftermarket speakers. Made with correct connector for hook-up to current GM replacement speaker and correct connector for connection to original wiring, or cut off connector for hook-up to current GM replacement speaker and solder wires directly to original speaker (as was done originally) or aftermarket speaker.
Keeps your battery fully charged and maintained to extend battery life. Monitoring circuitry automatically turns... see moreKeeps your battery fully charged and maintained to extend battery life. Monitoring circuitry automatically turns charger on & off as needed. Fully protected against overcharging, short circuits, and reverse polarity. Features red/green LED indicator light status. Includes both clamp and fused ring-terminal connection adapters. Works on all 6 or 12 volt lead-acid Wet/AGM/Gel batteries. Plug charger it into any 110 volt socket, connect to your battery, and forget about it!