internal circuit board to Transistor Ignition Auxiliary Harness distributor connector, Note: This harness will work with any Delco Transistor Ignition amplifier being rebuilt/restored using part #VTR6571AM TRANSISTOR IGNITION AMPLIFIER BOX MODULE
Additional information
Lectric Limited Part #
90271
WebID Part #
id-90271-0001
Weight
0.5 lbs
You have not selected a vehicle
Also fits*:* This fit is only a guideline. Please verify the fit by entering your specific vehicle.
Make
Model
Years
PONTIAC
FULLSIZE/GRAND PRIX
1963
PONTIAC
TEMPEST/LEMANS/GTO/T-37/GRAND AM/VENTURA
1963
TECH NOTES:
The Transistor Ignition (T.I.) Amplifier Box Extension is the short wiring that goes from the internal circuit board (inside the T.I. box) that includes the rubber molded T.I. Amplifier box housing connector -to- the T.I. Auxiliary Harness's molded rubber connector. Basically, it is the wiring exiting the amplifier box.
This extension appears to be is the weakest link in the entire T.I. system and must be replaced if you have not already done so. Over the years, the spring-tension on the female terminals of this wiring will lose their grip on the male terminals they connect to, causing your engine to quit!
use with 700R4 or 2004R automatic trans. EXCEPT 4L60E or 4L80E. Completely externally installed kit... see moreuse with 700R4 or 2004R automatic trans. EXCEPT 4L60E or 4L80E. Completely externally installed kit allows for automatic operation of the torque converter lock-up (overdrive) without installing the computer!!!! Kit includes instructions.
This handy cut-off switch lets you quickly and easily disconnect your battery for safety when... see moreThis handy cut-off switch lets you quickly and easily disconnect your battery for safety when servicing your vehicle or in storage, to eliminate battery drain while vehicle is not in use, and for security as an anti-theft device. Install on the negative post of your battery, attach battery cable to the switch and you're done! To engage power close the lever (made of quality solid copper). To disconnect power open the lever.
front single dash speaker, Use when installing original, replacement, or aftermarket speaker. Made with correct... see morefront single dash speaker, Use when installing original, replacement, or aftermarket speaker. Made with correct connector for hook-up to current GM replacement speaker and correct connector for connection to original radio or radio harness. You can cut off connector for hook-up to current GM replacement speaker and solder wire directly to original speaker (as was done originally) or aftermarket speaker.